ELBRO TESTY 2 - Page 4

© 2 0 1 7 b y E L B R O A G / G i o r g i o B o v e n z i TESTY 2 S e i t e 4 / 20
Symbols
Symbols marked on instrument and in instruction manual:
Warns of potential danger, observe the advice given in the instruction manual.
Danger of electrical shock.
Note, Information.
Continuous, double or enhanced insulation is in compliance with class II IEC 60536.
Conformity symbol, the instrument complies with the valid directives. It complies with the EMC Directive
(2014/30/EU). It also complies with the low voltage directive (2014/35/EU). The standards EN 61010-1 are
fulfilled.
Instrument according directive (2012/19/EU) WEEE
CAT III/300V
Instrument complies to Measurement Category CAT III / 300 V against Earth.
Description of measurement categories:
CAT I is for measurements performed on circuits not directly connected to mains, i.e. battery powered instruments.
CAT II is for measurements performed on circuits directly connected to the low voltage installation, i.e. household
appliances, portable tools and similar equipment.
CAT III is for measurements performed in the building installation, i.e. distribution boards, circuit breakers, wiring,
including cables, bus-bars, junction-boxes, switches, socket- outlet in the fixed installation, and equipment for
industrial use and some other equipment, for example, stationary motors with permanent connection to the fixed
installation.
CAT IV is for measurements performed at the source of the low voltage installation, i.e. electricity meters.