ELCA Amaltea 2 - Advanced Programming Functions; Courtesy Lamp Code Programming; Working Time Programming; Pause Time Programming

3
C- COURTESY LAMP CODE PROGRAMMING
(if you need to switch the lamp by the transmitter)
C1- push two times the button the led flash
C2- send a code (not yet in memory) from the transmitter, the led stop
flashing for 0,5 seconds.
It’s possible to memorizing more codes.
- To erase the lamp codes follow the step
P1 OK
A-5 or a RESET
NOTE : Programming the code to command the courtecy lamp doesn't exclude its lighting
for 3 min at every movement.
P1
2 impulses
Led OK
Flashing
C1
Led OK
Turn off for
0,5 sec
C2
D- WORKING TIME PROGRAMMING
Off On
1 Pause
2 Times
Dip
Led OK
2° impulse
1° impulse
Start/stop
5
6
D2
Off On
1 Pause
2 Times
Dip
Led OK
E- PAUSE TIME PROGRAMMING (only required on automatic closing)
Off On
1 Pause
2 Times
Dip
Led OK
Off On
1 Pause
2 Times
Dip
E1
(Only use if the door takes longer than 30 seconds
--- place the door in closed position ---
D1 - turn dip switch n.2 on the board to on the
OK led should be on
D2- Send an impulse from hand set or by a switch with the
connected on 5-6 on the PCB, the door should start to open if not,
swap wires n.12 and n.13,and try again, the door should open, when
the door is fully opened give a signal again from hand set, or press the
switch to stop door,then turn off dip switch n.2 off on the PCB.
(Max time = 4 minutes)
D3- set the dip n.2 in OFF position
E1- turn on dip switch n.1 in ON (the OK led comes on) leave it on
for the desired time, max 4 minutes, turn off dip n.1 photocells
should be used when using this function.
Replace dip n.1 in OFF position.
OTE : If you want the door to stay open for a longer period in this mode, send a signal
from hand set the door will stay open untill you send another signal.
N
D3
D1
To open)