ELCA Amaltea 2 - User Manual

This manual contains very important instructions for the installation, and use of this control board mod.
Do not install prior to reading this manual, the best results depends upon the correct application , installation.
We the manufactures of this product declines any responsibility in the case of an incorrect installation or improper use ,
And should be installed by a qualified person. This product has been created by keeping the strictest safety norms following
EC directives : CEE73/23, CEE89/336, CEE93/68, CEE89/106, CEE89/392.
AMALTEA-2.
STOP
P1
Led ON
OK
RECEIVER
DIP
Led
A
B
C
Courtesy Light
Flashing light
Motor
Com
220Vac
Antenna
Stop
Button.
Start/Stop
C
B-
A
- Only rolling code
Theft proof’s function
- Tampering
Off ON
1 Pause
2 Times
omnipolar
230V 50Hz
4
5
1
23
4
5
TX
24 Vac
Photocell
Photocell
TERMINALS CONNECTION
1-2
3-5
4-5
6-5
7-8
9-10
11-12-13
14-15 power supply 230 Vac - 50 Hz )
11-14
ANTENNA terminal n.1=RF
STOPcontact, normally close.
PHOTOCELL contact, normally close
START/STOP contact, normally open
output 24 Vac max feeding 2 photocells
courtesy lamp contact (max 5A-230V) free voltage contact
connection for monophase motor 500W max (terminal n.11=common)
flashing light connection 230V-25W
(TERMINAL 14=NEUTRAL
!
FOLLOW THESE INSTRUCTION CAREFULLY !!!
!
ATTENTION !!
During the installation it’s important to have a switch with
contact opening of at least 3mm that assurse an omnipolar
disconnection of the board to the current network . Procede
with a correct motor grounding.
Control board for
rolling-shutters and
blinds’ automation with:
-rolling code
-cortecy lamp contact
Amaltea 2
Soldering bridges
RX
1
Switch
ELCA snc Tel. 0039 0734 608484
Via Malintoppi, 32 Fax 0039 0734 605080
63023 FERMO (AP) e-mail: elcasnc@tin.it
ITALY web: www.elcasnc.com
This manual has to stay with the equipment at all time, must not remove!
!
FOR SAFETY REASON A SAFETY DEVICE
MUST BE USE WHEN USING THIS REMOTE CONTROL

Summary

Amaltea 2 Control Board Overview and Safety

General Instructions and Safety Warnings

Important instructions for installation, usage, and safety compliance with EC directives.

Terminal Connections Guide

Detailed guide for connecting power, motor, safety devices, and accessories to the control board terminals.

Basic Operation and Programming

Resetting the Control Board

Procedure to return the control board to its basic factory code or program settings.

Radio Code Programming

Instructions for programming standard or rolling codes from a handset to the receiver.

Stop Code Programming

Procedure for programming stop codes, though noted as unavailable.

Advanced Programming Functions

Courtesy Lamp Code Programming

Programming the control board to activate the courtesy lamp via transmitter.

Working Time Programming

Setting the maximum door opening or closing time for automated systems.

Pause Time Programming

Configuration for pause time, primarily used with automatic closing functions.

Special Functions, Features, and Warranty

Special Functions: Rolling, Theft & Tamper Proof

Configuration of rolling code, theft proof, and tamper proof functions using solder bridges.

Product Features and Specifications

Overview of the control board's technical features, power supply, and physical specifications.

Warranty Information

Details on the product warranty, coverage, and return policy.

ELCA Amaltea 2 Specifications

General

Brand	ELCA
Model	Amaltea 2
Category	Control Unit
Language	English