To Next PageTo Next Page
Need help?Do you have a question about the elco VG2.120 M/TC and is the answer not in the manual?
General| Brand | elco |
|---|---|
| Model | VG2.120 M/TC |
| Category | Indoor Fireplace |
| Language | English |
Instructions for Elco gas burners, aimed at specialist engineers.
Overview of the manual's main topics: Operation, Assembly, Commissioning, Maintenance.
Labels and descriptions of key burner components and parts.
Details on the safety mechanisms and shutdown procedures of the burner.
Procedures for manually locking and unlocking the control unit.
Detailed pin assignments for connectors X01 through X10.
Pin assignments for connectors X30, X31, X32, X33, and X34.
Sequence diagram illustrating the operation of the control unit during gas firing.
Explanation of how to navigate the BT 3xx control unit menus and their functions.
Technical specifications and description of the MBC-SE gas train assembly.
Step-by-step guide for physically installing the burner into the boiler.
Instructions for installing the burner tube and surrounding brickwork.
Steps for correctly connecting the gas train to the burner and diaphragm.
Procedures for setting up combustion components for propane gas.
Essential checks to perform before the initial commissioning of the burner.
Procedure for measuring the ionisation current for flame monitoring.
Table of adjustment values for different burner types and operating modes.
Instructions for setting the pressure regulator on the MBC-SE gas train.
Process for confirming or cancelling modifications made via manual handshake.
Procedure for setting servomotor positions without the burner being ignited.
Important advice and checks to perform before starting the burner after settings.
Step-by-step guide for setting servomotor positions while the burner is operating with flame.
Procedure for setting the burner to the ignition position and adjusting combustion values.
How to adjust low and high load limits for dual fuel burners.
Understanding the display in operating mode showing status, flame signal, and operating time.
Procedures for correctly setting the gas and air pressure switches.
How to view the configured servomotor positions on the manual control display.
List of recommended tasks for annual burner maintenance.
Procedures for replacing the burner flame tube and the filter element.
Interpretation of symbols and causes for burner faults.
Further fault signals and their potential causes and remedies.
Accessing and interpreting burner operating statistics like start-ups and operating hours.
How to adjust the brightness and contrast of the burner's control display.
