elco VG 1.105 D E - User Manual

Questions and Answers

A
Adam JohnsAug 7, 2025
Why elco VG 1.105 D E Indoor Fireplace burner does not start after thermostat shutdown?
- D
  Dustin PittmanAug 7, 2025
  If the elco Indoor Fireplace burner does not start after a thermostat shutdown and there's no malfunction indicated on the automatic combustion control unit, it could be due to a drop in supply voltage, a power failure, or a control unit malfunction. Check the cause of the fall in voltage or the power failure. If the problem persists, replace the control unit.
S
Sara WilliamsAug 12, 2025
Why does elco VG 1.105 D E Indoor Fireplace burner switch off during operation?
- D
  Dr. Melanie SalazarAug 13, 2025
  If the elco Indoor Fireplace burner switches off during operation, the air pressure switch contact may be opening during start-up or operation. Adjust or replace the pressure switch to resolve this issue.
K
kjonesAug 17, 2025
What to do if elco Indoor Fireplace burner blower starts but burner does not start?
- J
  Jacob EllisonAug 17, 2025
  If the elco Indoor Fireplace burner blower starts up, but the burner does not start, it could be because the air pressure switch contact does not close. Check the pressure transmitter for foreign bodies and examine the wiring.
T
teresa13Aug 22, 2025
What causes elco Indoor Fireplace burner to switch off during operation?
- C
  catherine55Aug 22, 2025
  If the elco Indoor Fireplace burner switches off during operation, check the ionization sensor circuit. You may also need to check or replace the automatic combustion control unit.
R
rrodriguezAug 27, 2025
What to do if elco Indoor Fireplace burner does not start?
- K
  Kenneth McdonaldAug 27, 2025
  If the elco Indoor Fireplace burner does not start, it might be because the air pressure switch is not in the rest position, is incorrectly adjusted, or the contact is welded. Readjust or replace the pressure switch.
D
Deborah CombsNov 1, 2025
What to do if the elco VG 1.105 D E Indoor Fireplace burner starts then fails?
- M
  matamarciaNov 2, 2025
  If the elco Indoor Fireplace burner starts, the ignition switches on, but then fails, it could be due to several reasons. There might be no flame after the safety time, the gas throughput could be set incorrectly, or there might be a malfunction in the flame monitoring system. Other potential causes include no ignition sparks, short-circuited electrode(s), a damaged or defective ignition cable, a defective ignition transformer, a faulty automatic combustion control unit, solenoid valves that don't open, or valves that are jamming. To resolve this, adjust the gas throughput. Check the condition and position of the ionization sensor. Inspect the connections of the ionization circuit. Adjust, clean, or replace the electrode(s). Connect or replace the cable(s). Replace the transformer or the c...