Need help?Do you have a question about the Elcon NT1+2a/b and is the answer not in the manual?
General| Category | Modem |
|---|---|
| Model | NT1+2a/b |
| Analog Ports | 2 |
| Power Supply | External |
| Compliance | ETSI |
| Interface | S0 |
| Connectors | RJ45 |
Connecting the NT1+2a/b to the ISDN line via the U interface connector.
Connecting analogue and ISDN terminal equipment to the NT1+2a/b ports.
Configures up to three telephone numbers (MSNs) per analogue port for call handling.
Sets overall device mode (e.g., full functionality, S/T only, analogue ports off).
Manages active calls, allowing one call to be put on hold while attending another.
Redirects incoming calls to another number based on conditions like busy or no reply.
Selects between short passive bus and point-to-point S/T bus configurations.
To Next Page
