Elcontrol Vip Energy 2K8 ALM HARMO User Manual

Energy & Harmonics Analyser
Energy & Harmonics Analyser
Via Vizzano 44 - 40037 Pontecchio Marconi (Bologna)Italy
Tel. +39 051 6782006 - Fax +39 051 845544
http://www.elcontrol-energy.net
e-mail: vendite@elcontrol-energy.net
sales@elcontrol-energy.net
ENGLISH
USER MANUAL
USER MANUAL
3YYYB125 Vip Energy 2k8 User Manual Eng Rel.01/2009
WARNING  Elcontrol Energy Net S.r.l. declines all liability for any damage to people or property caused by unsuitable or incorrect
use of its products. Elcontrol Energy Net reserves the right to change product specifications without prior notice.
VIP
VIP
ENERGY
ENERGY
2K8
2K8
ALM - HARMO
ALM - HARMO

Elcontrol Vip Energy 2K8 ALM HARMO Specifications

General

Display	LCD
Harmonic Analysis	Yes
Communication	Modbus RTU
Measurement Category	CAT III
Current Range (AC)	Via external current transformer
Frequency Range	45-65Hz
Safety Standards	IEC 61010

Summary

Energy & Harmonics Analyser USER MANUAL

THREE PHASE (DELTA / STAR) CONNECTION, QUICK REFERENCE MEASURES PAGES

DIPHASE CONNECTION QUICK REFERENCE MEASURES PAGES

SINGLE-PHASE CONNECTION QUICK REFERENCE MEASURES PAGES

SETUP PAGES (ALL MODELS)

SETUP PAGES ALM VERSION

DISPLAYED MEASUREMENT

WIRING DIAGRAMS MEASURES INPUTS

POWER SUPPLY CONNECTION

LABELS

DIMENSIONS

1 - INTRODUCTION

1.1 STANDARDS and REGULATIONS

Lists relevant standards and regulations compliance for the instrument.

1.2 USER SAFETY

Crucial safety instructions and precautions for instrument operation and installation.

1.3 PRELIMINARY INSPECTIONS

Checks to perform before installing the instrument to ensure it's in good condition.

1.4 PRECAUTIONS IN THE EVENTS OF MALFUNCTIONS

Actions to take if the instrument malfunctions or is damaged, ensuring safe operation.

2 - CONNECTION OF THE INSTRUMENT

2.1 POWER SUPPLY

Details on connecting the instrument's power supply terminals and requirements.

2.2 CONNECTING VOLTAGE MEASUREMENT CABLES

Instructions for connecting voltage measurement cables to the instrument.

2.3 CONNECTING CURRENT MEASUREMENT CABLE

Guidance on connecting current measurement cables and external Current Transformers (CTs).

3 – MEASUREMENTS PAGES

4– SETUP PAGES (ALL THE MODELS)

4.1-SETUP PAGE PROTECTION CODE

Instructions for setting or changing the access password for the setup menu.

4.2 - SETUP PAGES

General overview of accessing and navigating the instrument's setup menus.

5- SETUP PAGES

5.1 - RELAYS or ALARM OUTPUT

Configuration of the instrument's alarm and relay output functions.

5.2 - PULSES OUTPUT

Setup and configuration of the pulse output for energy metering.

6 – TECHNICAL CHARACTERISTICS

7-RS485 SERIAL OUTPUT