9-2
SECURITY
DIAMOND STANDARD WHEEL LOCK
How to fit your Diamond Standard
Wheel Lock
1. The Diamond Standard Wheel Lock is
fitted to the nearside wheels.
2. Move the caravan until the receiver is
located between the wheel spokes
(Fig 1).
3. Push the Diamond Standard Wheel Lock
between the rim spaces so that the bolt
fits into the receiver (Fig 2).
4. Push the Diamond Standard Wheel Lock
up to the point where the base plate
contacts the rim (Fig 3).
5. Lock the Diamond Standard Wheel Lock
with the attached key (Fig 4).
Hints for using the Diamond
Standard Wheel Lock
To keep the hole of the receiver clean, please
use the supplied plug when the Diamond
Standard Wheel Lock is not mounted.
Key Card
The number of the lock is only recorded on
the key card. Without this card you will be
unable to order any replacement keys.
Please keep your key card in a safe place
and at all times separate from the wheel lock.
A jack is required to fit the second wheel lock
and this is provided with your new caravan
and should only be used for this purpose.
Fig 2
Fig 3 Fig 4
Fig 1
To Next Page
Loading...
