Eldes EWP3 - Page 20

20
EWP3 WIRELESS MOTION DETECTOR
For the purpose of tesing this mode might be ignored when using Coniguraion sotware or if the service mode is enabled.
When the power saving mode is enabled, the system can be armed even if any movement is detected in the guarded premises. Ater the
successful arming process, PIR sensor awakes; in case the PIR sensor detects any movement, then the system will cause an alarm. If it is
important for user to monitor the premises during the arming process, then we strongly recommend NOT to use the power saving mode.
MOVEMENT DETECTION CONDITIONS
SYSTEM STATE DISARMED STAY ARMED ARMED
ZONE
ATTRIBUTES
NOT STAY STAY NOT STAY STAY NOT STAY STAY
Power saving mode ON and Service mode OFF and Conig-
uraion Sotware OFF and zone type is Instant or Interior
Follower
DISABLED DISABLED ENABLED DISABLED ENABLED ENABLED
Power saving mode OFF or Service mode ON or Coniguraion
Sotware ON or zone type isn’t Instant or Interior Follower
ENABLED ENABLED ENABLED ENABLED ENABLED ENABLED