Eldes EWP3 - Battery Replacement

21
EWP3 WIRELESS MOTION DETECTOR
6. BATTERY REPLACEMENT
1. Open EWP3 enclosure.
2. Remove the old bateries from the batery slots.
3. Insert the new Primary 3V Lithium 1500mAh CR123A type bateries based on the batery slot posiive/negaive terminals.
4. Bateries replaced.
• We strongly recommend to use quality brand bateries, such as: GP, Ansmann,Energizer.
• Only Primary 3V Lithium 1500mAh CR123A bateries can be used. Install only new, high quality and unexpired batery.
• All bateries must be removed or plasic tab inserted between batery slot and the batery if the device is not in use.
• EWP3 device is able to work with just 1 batery, thus we strongly recommend to use BOTH bateries to maintain a longer operaional ime.
• To to avoid ire or explosion hazards, the system must be used only with approved batery. Special care must be taken when connecing posiive
and negaive batery terminals. Dispose old bateries only into special collecion sites. Do not charge, disassemble, heat or incinerate old bateries.
• The batery status can be monitored in real-ime using ELDES Coniguraion sotware.
• The system sends an SMS text message to the listed user phone number as soon as the batery level runs below 5%.