ADR-Auto Range
2 9901X0215 Issue 5
Contents
Section Page
Figure 1 Arrangement of Compression Frames
and Footprint Dimensions 6
Figure 2 The ADR-Auto Range 7
Figure 3 Oil Filler and Bleed Screw Locations 8
Figure 4 Upper Platen Assemblies 9
1 Introduction
1.1 Compression Frames 10
2 Specification
2.1 Console 10
2.2 Compression Frames 11
2.3 Upper Platen Assemblies 11
3 Installation
3.1 Moving, Lifting and Siting 11
3.1.1 Moving, Lifting and Siting the 250kN
Compression Frame
3.1.2 Moving, Lifting and Siting the 1500, 2000
and 3000 kN Compression Frames
3.1.3 Moving, Lifting and Siting the Console
3.2 Connecting the Compression Frame
to the Console 12
3.2.1 Connecting the Hydraulics
3.2.2 Connecting the Ram Travel Limit
Switch Lead
3.2.3 Connecting to the Mains Supply
3.3 Preparing the Hydraulics 12
3.3.1 Checking the Oil Level
3.3.2 Bleeding the Hydraulic System
3.4 Distance Pieces 13
4 ADR-Auto Console
4.1 Foreword 14
4.2 ADR-Auto Measurement Modes 14
4.3 Front Panel Display and Controls 14
4.3.1 Display
4.3.2 Function Keys
4.3.3 Keypad
4.3.4 LCD Contrast
4.4 Electrical Connections 15
4.5 Turning the ADR-Auto On 16
4.5.1 Initial Display
To Next Page
Loading...