Need help?Do you have a question about the ELECRAFT KPA500 and is the answer not in the manual?
Explains critical safety warnings and cautionary notes for operating the equipment.
Procedure for setting the fuse block and internal jumpers to match the supply voltage.
Details on adjusting the power supply transformer taps for correct mains voltage operation.
Procedure to test the power supply voltage output and verify correct transformer tap selection.
Guidelines for providing adequate clearance for cooling air flow around the amplifier.
Key notes for connecting station ground, RF input/output, and transmitter keying circuits.
Step-by-step guide to safely powering on the Elecraft KPA500 amplifier.
Details on automatic, manual, and coordinated band switching with transceivers.
Procedure for using the amplifier for transmission, including drive levels and monitoring.
Guidance on using Automatic Level Control (ALC) correctly to avoid distortion.
How to monitor amplifier parameters using LEDs and the LCD display.
Information on controlling the KPA500 remotely via a personal computer.
Overview of the menu system and how to set various operational parameters.
Instructions for downloading and installing updated firmware for the KPA500.
How to determine the currently installed firmware version using the menu.
Steps to calibrate the KPA500's internal wattmeter to match an external meter.
Contact information and procedures for obtaining technical support from Elecraft.
Instructions for returning the product for repair or alignment service.
Details of the Elecraft 1-year limited warranty coverage for kits and assembled products.
Detailed pinout for the DE-15 male AUX connector, including signal names and directions.
Pin connections for Icom radios using DIN13 or DIN7 connectors with the KPA500.
Table of band codes used by the KPA500 for BCD band switching.
To Next Page
General