Need help?Do you have a question about the ELECRAFT KXPA100 and is the answer not in the manual?
Lists the main unit and optional tuner.
Describes the unit's handle for portability.
Lists included cables and accessories.
Instructions for positioning and connecting the unit.
Details connecting the amplifier to a KX3 transceiver.
Details connecting the amplifier to an FT-817 transceiver.
Details connecting the amplifier to other transceivers.
How to measure voltage/current for external amp key lines.
Explains buttons and lights on the front panel.
Explains the function of the rear panel attenuator switch.
Setup steps for KX3 operation.
How to operate the amplifier with a KX3.
How to control the ATU via the KX3.
Setup steps for FT-817 operation.
How to operate the amplifier with an FT-817.
How to control the ATU via the FT-817.
Setup steps for general transceiver operation.
How to operate the amplifier generally.
General procedures for using the ATU.
Instructions for launching the software.
Steps to update the amplifier's software.
Recovery for firmware loading errors.
Using software to monitor amplifier status.
Utility error codes and their meanings.
Saving and loading ATU configurations.
Updating KX3 firmware using the utility.
Technical specifications for the amplifier.
Technical specifications for the ATU.
Functional overview of the amplifier's internal workings.
Functional overview of the ATU's internal workings.
Wiring diagram for the KX3 adapter cable.
Wiring diagram for the serial interface cable.
Wiring diagram for the FT-817 interface cable.
Procedure to set ALC for output power control.
Instructions for accessing internal components.
Lists the items required for calibration.
Step-by-step guide to calibrate output display.
How to check the calibration outcome.
Restoring the amplifier's default calibration.
Contact information for technical help.
Information on returning the product for service.
Details of the product's warranty coverage.
General| Power Output | 100 W |
|---|---|
| Frequency Range | 1.8 - 54 MHz |
| Input Impedance | 50 ohms |
| Frequency Coverage | 1.8 - 54 MHz |
| Supply Voltage | 13.8V DC |
| Current Drain | 20 A |
| Modes | SSB, CW |
| Harmonic Distortion | > -50 dB |
| IMD | -30 dB |
To Next Page
