Need help?Do you have a question about the Elecro Engineering EVOLUTION and is the answer not in the manual?
General| Brand | Elecro Engineering |
|---|---|
| Model | EVOLUTION |
| Category | Swimming Pool Heater |
| Language | English |
Identifies key physical parts of the EVO pool heater, including indicators, controls, and fittings.
Details the foot arrangement for securing the heater in a floor-based installation.
Explains how to adjust the foot mounting for vertical installation against a wall.
Specifies minimum pipe bore, safety loops, and hose clip usage for heater connection.
Mandates a dry enclosure and advises on draining for winter to prevent frost damage.
Requires connection by a qualified electrician, RCD use, and potential gland replacement.
Details power outputs (kW) and corresponding voltage (V) and amperage (A) for models.
Defines minimum water flow rates for operation and how to reverse the flow switch direction.
Lists acceptable water quality parameters: pH, alkalinity, chloride, chlorine, bromine, TDS.
Guide on initial start-up, air purging, and conditions for the heater to switch to 'On' mode.
Discusses factors influencing pool heating time, including heat loss and insulation.
Provides methods for quick and accurate testing of heater performance using meter readings.
Covers reasons for failure to switch from standby to 'On', including set point and safety cut-out.
Addresses issues where no lights appear on the heater, often due to external power problems.
Explains why the flow tube might feel warm, possibly due to sunlight or trapped air pockets.
Clarifies how temperature gain is related to flow rate and heater output, not just flow speed.
Statement confirming compliance with RoHS Directive regarding hazardous substances.
Instructions for proper disposal of the product as WEEE, not as unsorted municipal waste.
To Next Page
