6
IMPORTANT
Unpacking instructions
All transit bolts and packing must be removed
before using the appliance.
Note: Your electricity company cannot accept
responsibility for damage to your machine if
you operate it without removing the transit
bolts and packaging.
You are advised to keep all the transit bolts and
packaging for re-use in case the appliance has to be
transported again.
■
Unscrew and remove the three rear transit bolts
(using a 10 mm hexagonal spanner).
■
Lay the machine gently on its back, making sure
that the hoses are not squashed.
We suggest a polystyrene angle bracket from the
packing is placed on the floor before tilting it back
to avoid the hoses being squashed.
■
Carefully remove the polyethylene bags located at
the base of the machine by pulling them toward the
centre of the machine.
■
Place the machine in an upright position and
remove the three plastic bolts.
■
Plug the 3 holes with the plastic plugs which you
can find in the envelope containing the instruction
booklet.
To Next Page
Loading...