Electra TG50W - Gas Connection and Leakage Checks

15
It is advised that there is a 2cm blank space around the product
for air circulation.
(The minimum distance between the pan support and any wall
cupboards or cooker hoods with a fan over the product, are
shown in the above gure.) The cooker hood must be at minimum
65cm height from the pan support. If there is no cooker hood,
this height must not be less than 70cm.
2.3 Gas connection
Assembly of gas supply and leakage check
The connection of the appliance should be performed in
accordance with local and international standards and regulations
applicable. First check what type of gas should be installed to
the cooker. This information is given by a sticker on the back of
the cooker. You can nd the information related to appropriate
gas types and appropriate gas injectors on the technical data
table. Check that the feeding gas pressure is compliant with
values on the technical data table, to get maximum efciency
and to ensure the least consumption. If the pressure of used
gas is different to the values stated or not stable in your area,
it may be necessary to assemble pressure regulator on the gas
inlet. It is essential that you contact an authorized service agent
to make these adjustments.
The points that must be checked during exible hose assembly
If the gas connection is made by a exible hose that is xed on
the gas inlet of the appliance, it must be xed by a pipe collar.