EasyManua.ls Logo

electrifly Spad XIII User Manual

electrifly Spad XIII
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Great Planes
®
Model Manufacturing Co. guarantees this kit to
be free from defects in both material and workmanship at the date
of purchase. This warranty does not cover any component parts
damaged by use or modifi cation. In no case shall Great Planes’
liability exceed the original cost of the purchased kit. Further,
Great Planes reserves the right to change or modify this warranty
without notice.
In that Great Planes has no control over the fi nal assembly or
material used for fi nal assembly, no liability shall be assumed nor
accepted for any damage resulting from the use by the user of
the fi nal user-assembled product. By the act of using the user-
assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to return
this kit immediately in new and unused condition to the place
of purchase.
To make a warranty claim send the defective part or item to Hobby
Services at the address below:
Hobby Services
3002 N. Apollo Dr., Suite 1
Champaign, IL 61822 USA
Include a letter stating your name, return shipping address, as
much contact information as possible (daytime telephone number,
fax number, e-mail address), a detailed description of the problem
and a photocopy of the purchase receipt. Upon receipt of the
package, the problem will be evaluated as quickly as possible.
READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT
INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.
Champaign, Illinois
(217) 398-8970, Ext 5
airsupport@greatplanes.com
WARRANTY
INSTRUCTION MANUAL
Entire Contents © Copyright 2008
GPMA1143Mnl V1.0
Wingspan: 34 in [865mm]
Wing Area: 390 sq in [25.2dm
2
]
Weight: 22.4 - 25.2 oz [635 – 715g]
Wing Loading: 8.3 – 9.3 oz/sq ft [25 – 28g/dm²]
Length: 27 in [685mm]
Radio: 4-Channel (minimum) with Micro Receiver, Four Micro Servos
Motor: ElectriFly
RimFire
28-30-950 Brushless
Propeller: Great Planes
®
10x3.5 Slo-Flyer Electric Propeller (GPMQ6655)
ESC: ElectriFly
SS-25
Battery: 11.1V, 1250mAh LiPo (must deliver 15 amps continuous)
Question and Answer IconNeed help?

Do you have a question about the electrifly Spad XIII and is the answer not in the manual?

electrifly Spad XIII Specifications

General IconGeneral
Brandelectrifly
ModelSpad XIII
CategoryToy
LanguageEnglish

Summary

Important Safety Precautions

Lithium Battery Handling and Usage

Crucial safety guidelines for charging and handling LiPo batteries to prevent damage and harm.

Before You Begin Assembly

Prepare for Tail Installation

Steps for preparing the tail section before attaching it to the fuselage.

Tail Installation

Install the Tail to the Fuselage

Detailed instructions for attaching the assembled tail section to the aircraft's fuselage.

Install Servos

Elevator & Rudder Servos Installation

Instructions for installing the servos for the elevator and rudder control surfaces.

Prepare the Wings

Install the Aileron Servos

Guide for installing the servos that control the ailerons on the wings.

Get Model Ready to Fly

Center Controls & Check Directions

Procedure for centering control surfaces and verifying correct response to radio inputs.

Set Control Throws

Balance the Model (C.G.)

Balance the Model Laterally

Preflight Checks

Range Check

Motor Safety Precautions

AMA Safety Code (Excerpts)

Comprehensive Checklist

Radio Control Setup and Checks

Takeoff Procedure

Flight Maneuvers

Landing Procedure