Page 8 of 23
OPERATION
TURNING ON AND OFF
The STANDBY button can be pressed to enter and exit standby mode. If the unit is not to
be used for a while, we would advise for it to be turned off using the switch on the side and
unplugged.
CHANGING THE DESIRED ROOM TEMPERATURE
The desired room temperature can be adjusted in both High heat and Low Heat modes,
using the UP and DOWN buttons. After the UP or DOWN button has been pressed, the
temperature display will show the desired temperature. The desired temperature can be
adjusted between 10°C and 49°C.
CHILD LOCK
Press and hold the UP and DOWN buttons for 3 seconds to activate and deactivate the
child lock. When the child lock is activated the Child lock symbol will be shown on the
display and the buttons are disabled on the control panel until the child lock is deactivated.
CHANGING THE POWER LEVEL
Repeatedly press the MODE button to change between the 3 available power modes:
The heater will operate at High Power(2KW), the desired
temperature can be specified between 10°C and 49°C.
The heater will operate at Low Power (1KW), the desired
temperature can be specified between 10°C and 49°C.
The heater will operate to keep the room temperature between 5°C
and 9°C in order to prevent freezing within the room. The desired
temperature cannot be changed.
OPEN WINDOW DETECTION
Hold Mode for 3 seconds to select Open Window Detection Mode. In this mode, when the
ambient temperature drops by 5°C. within 10 minutes, the heater will register the
possibility of an open window in the room. If this happens, it will stop heating
and enter standby mode.
To Next Page
Loading...
General