Why is my Electro-Voice Speaker System making a constant buzzing noise?
If your Electro-Voice Speaker System is producing constant noise like buzzing, hissing, or humming, and no audio is playing, the issue likely resides within the signal chain of the electronics. Evaluate each component to isolate the source of the noise. Also, check and correct the system grounding, as required, to eliminate potential ground loop issues.
What to do if my Electro-Voice Speaker System has crackling sound?
If your Electro-Voice Speaker System experiences intermittent output issues such as crackling or distortion, begin by inspecting all connections at both the amplifier and speakers. Ensure that all connections are clean and tight. If the problem persists, the fault may be in the amplifier or wiring. Refer to the troubleshooting steps for 'No Sound' to further diagnose the issue.
How to troubleshoot no sound on my Electro-Voice Speaker System?
If your Electro-Voice Speaker System has no sound, start by checking the amplifier. Connect a known working test loudspeaker to the amplifier outputs. If there's still no sound, ensure all electronics are powered on, the signal routing is correct, the source is active, and the volume is turned up. Correct, repair, or replace components as needed. If sound is present, the issue lies within the wiring. Alternatively, examine the wiring by verifying that you've connected the correct wire pairs to the amplifier. Play audio at a low level through the amplifier. Connect the test loudspeaker in parallel with the malfunctioning line. If the sound level diminishes or is very weak, the line likely has a short. If the sound level is normal, the wire is open. Use the test loudspeaker to move down the ...
General| Brand | Electro-Voice |
|---|---|
| Model | EVU-2082/95 |
| Category | Speaker System |
| Language | English |
To Next Page