2. Insert the batteries.
Note: Do not expose the remote sensor of the
DVD Player to a strong light source, such as direct
sunlight.
Notes:
Improper use of batteries may cause battery
leakage and corrosion. To operate the remote
control correctly, follow the instructions below:
Do not insert the batteries in the wrong direction.
Do not charge, heat, open, or short-circuit the
batteries.
Do not throw the batteries into a fire.
Do not leave dead batteries in the Remote Control.
Do not use different types of batteries together, or
mix old and new batteries.
If you do not use the remote control for a long
period of time, remove the batteries to avoid
possible damage from battery corrosion.
If the remote control does not function correctly or
the operating range is reduced or limited
substantially, replace all of the batteries with new
ones.
If battery leakage occurs, clean the battery
compartment, then insert new ones.
8
To Next Page
Loading...