To Next PageTo Next Page
Need help?Do you have a question about the electroil Archimede ITTP1.5W-BC and is the answer not in the manual?
Instructions for mounting the inverter vertically, ensuring proper ventilation and space for heat dissipation.
Guidance on connecting the inverter to power, pressure transducer, and pump, covering various connection types.
Procedure for connecting the pressure transducer to new waterworks systems, specifying the pump's output pressure connection.
Steps for connecting the pressure transducer to older systems, including those with existing pressure or flow switches.
Recommendations for using a diaphragm tank for optimal pressure control and system stability.
Instructions for connecting the inverter output to single-phase pumps, including motor connection details.
Guidelines for correctly and safely connecting the inverter to the main power supply, ensuring compliance with regulations.
Safe procedures for opening the inverter and accessing its internal electronic components for maintenance or repair.
How to connect external contacts like float switches for pump control and safety interlocks.
Diagrams illustrating the internal electronic board layout and terminal connections for different inverter models.
Step-by-step guide for initial setup, self-regulation, and basic programming of the inverter for pump operation.
Procedure to verify the inverter stops the pump correctly under minimum flow conditions after self-regulation.
How to test the inverter's dry run protection, ensuring the pump stops safely when no water is present.
Instructions for configuring and operating multiple Blue Connect inverters in a master-slave group for coordinated pump control.
Guidance on accessing and adjusting advanced parameters via the control panel for fine-tuning system performance.
General| Input Voltage | 12V DC |
|---|---|
| Output Voltage | 230V AC |
| Power | 1.5W |
| Frequency | 50Hz |
| Protection | Overload, Short Circuit, Over Temperature |
