Electrolux 300 Series User Manual (English)

Other manuals for Electrolux 300 Series

Use & Care Guide46 pages

Installation Instructions50 pages

Use & Care Manual52 pages

Questions and Answers:

H
Heather FordAug 21, 2025
Why won't my Electrolux Washer start?
- J
  Joseph BrockAug 21, 2025
  Your Electrolux Washer might not start due to several reasons: * The power cord may not be properly plugged in. * A fuse may be blown, the circuit breaker tripped, or there may be a power outage. * The start/pause button may not be recognized if pressed incorrectly. * The water supply faucets may not be turned on. * The motor might be overheated (it will restart after cooling down). * The door may not be completely closed. To resolve this, ensure the plug is tightly fitted in the outlet, reset the circuit breaker or replace the fuse, press the start/pause button with a bare fingertip, turn on the water supply faucets, allow the motor to cool down, and ensure the door is closed.
S
Shawn VasquezAug 23, 2025
What to do if my Electrolux Washer has water leaks?
- S
  Stephanie ShawAug 23, 2025
  If your Electrolux washer is leaking water, check the following: * Ensure the fill hose connection is tight at both the faucet and the washer. * Make sure the dispenser drawer is completely closed. * Inspect the water hoses for any damage, cuts, or corrosion. Replace them if necessary. Check and tighten hose connections, close the dispenser drawer completely, and replace damaged hoses.
C
Catherine TorresAug 25, 2025
What to do if my Electrolux Washer isn't draining properly?
- G
  Grace PadillaAug 25, 2025
  If water in your Electrolux Washer does not drain or drains slowly: * Check if the drain hose is kinked or clogged; clean and straighten it. * Ensure the drain hose standpipe is not too tall; reduce its height to less than 8’ (2.4 m).
C
Calvin HartAug 27, 2025
Why is there so much lint on my clothes after using Electrolux 300 Dryer?
- V
  Victoria LucasAug 27, 2025
  Lint on clothes after drying in your Electrolux Dryer can be due to several reasons. It may be caused by overloading the dryer. If overloading is the case, reduce the load size and rewash using liquid fabric softener in the final rinse. Overdrying, which causes static electricity, can also be a cause. To solve this, add a fabric softener sheet and tumble without heat. Also, make sure that the lint screen is clean before starting a cycle. If the lint screen is not clean, use a lint brush or roller to remove lint. If the lint is attached to pills, use a lint brush or roller to remove the lint.
K
kathrynwalkerAug 27, 2025
How to clean residue stain buildup in the gasket of my Electrolux Washer?
- M
  Mr. Daniel WilliamsAug 27, 2025
  Residue stain buildup in the gasket of your Electrolux Washer can be caused by: * Moisture in the washer. * Use of non-HE detergent. * Overdosing detergent. * Overloading the wash drum. Perform a clean washer cycle. Scrub the gasket with Comet™ Spray Gel Mildew Stain Remover, using a brush to remove stains. Use only HE (high efficiency detergent) along with the recommended dosage. Remove the wash load immediately upon cycle completion.
W
William WestAug 29, 2025
How to clean residue stain buildup in the dispenser drawer of my Electrolux Washer?
- S
  Shelly SandersAug 29, 2025
  Residue stain buildup in the dispenser drawer or detergent pack not dissolving in your Electrolux Washer, can be caused by: * Moisture in the washer. * Use of non-HE detergent. Remove and clean the dispenser and inserts with a combination of ¾ cup liquid chlorine bleach and one gallon of hot water. Rinse well, and repeat if necessary. Use only HE (high efficiency detergent) along with the recommended dosage.
J
James FlowersAug 30, 2025
Why does my Electrolux 300 leave lint on clothes?
- D
  daltonjonesAug 31, 2025
  Lint on clothes after drying in your Electrolux Dryer can be due to several reasons: overloading the dryer (reduce load size and rewash using liquid fabric softener in the final rinse), overdrying causing static electricity (add a fabric softener sheet and tumble without heat), a lint screen that wasn't clean at the start of the cycle (use a lint brush or roller to remove lint), or lint attached to pills (use a lint brush or roller to remove lint).
T
Tom AndersonSep 1, 2025
How to prevent wrinkling in Electrolux Dryer?
- T
  Theresa BellSep 1, 2025
  To prevent wrinkling in your Electrolux Dryer, avoid overloading it. Reduce the load size and tumble the items at medium or low heat for 5-10 minutes. Also, remove items immediately after the cycle ends and hang or fold them promptly.
J
Joshua RamirezSep 2, 2025
How to get rid of lint on clothes from my Electrolux Washer?
- C
  cohenlauraSep 2, 2025
  To address lint issues with your Electrolux Washer: * Ensure correct sorting of clothes and reduce the load size. * Rewash using the correct water temperature, water level, and amount of detergent. * If tissues were left in a pocket, add a non-precipitating water conditioner to remove detergent residue. * For overloaded washers, add liquid fabric softener to the final rinse. * If undissolved detergent has left a residue, remove the lint with a lint brush or roller.
Y
yriceSep 4, 2025
Why is my Electrolux Washer leaving residue or powder on dark items?
- J
  Jacob JohnsonSep 4, 2025
  If you notice residue or powder on dark items or stiff, harsh fabrics after washing in your Electrolux Washer, it could be due to: * Undissolved detergent. * Granular detergents combining with hard water minerals. * Overloading the washer. To fix this, rewash the load. Increase the water temperature to the hottest safe for the fabric. Use liquid detergent or a non-precipitating water conditioner with powder detergent.

Electrolux 300 Series Specifications

General

Brand	Electrolux
Series	300 Series
Color	White
Dryer Venting	Vented
Number of Programs	12
Wrinkle Prevent Option	Yes
Moisture Sensor	Yes
Delay Start	Yes
Child Lock	Yes
Fuel Type	Electric
Drum Material	Stainless Steel
Type	Dryer
Voltage	240V