• Do not let cord hang over edge of table or counter, do not let cord contact hot surface,
including the stove.
• Never use accessories or parts made by other manufactures not recommended or sold;
may cause a risk of injury to persons.
• Make sure the motor has completely stopped before disassembling and cleaning.
• Avoid contact with moving parts. Contact could result in injury! Do not use other tools
or utensils during the appliance usage.
• Do not leave this product out of your sight when it is running.
• Ensure all loose matters and your clothes/accessories are kept away while using this
product.
• Never process boiling liquids (max 90°C).
• Do not use this appliance to stir paint. Danger, could result in an explosion!
•
unless the bowl is in place.
• This appliance is intended for domestic use only. The manufacturer cannot accept any
liability for possible damage caused by improper or incorrect use.
9
GB
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The motor slows down
during operation.
Amount of dough may exceed maximum
capacity.
Remove half and process in two
batches.
Dough may be too wet, it sticks onto the side
of the bowl.
until the motor speeds up. Process
until dough cleans the side of the bowl.
The motor does not work. The appliance is not connected to the mains. Make sure to plug in the appliance
before operation.
The appliance vibrates/
moves during operation.
The rubber feet are wet. Make sure the rubber feet at the
bottom of the unit are clean and dry.
It is normal for heavy loads (e.g heavy
dough, cheese).
Remove half and process in two
batches.
The tools usage, speed setting and max
capacity are not aligned with
recommendation.
Follow the recommended tools usage,
speed setting and capacity provided.
The Working light and
Power indicator light
The Speed selector has been left turned on. Turn the Speed selector to “Arrest”.
The attachment scrapes
the Stainless steel bowl
during operation.
The height of the attachment shaft is
incorrect.
Adjust the height of the attachment
shaft.
The motor head (A) is
shaky during mixing.
The motor head screw (U) is too tight. Turn the motor head screw
counterclockwise with screwdriver
around one full round. Please note
that too much adjustment can make
the tiltable motor head can’t be locked.
If this happen, turn the motor head
screw clockwise.
To Next Page
Loading...
