FlexiBridge Standard mode
This mode is activated by default when
you activate the function. It connects the
sections into two separate cooking
areas. You can set the heat setting for
each area separately. Use the two
control bars on the left side.
Correct cookware position:
Incorrect cookware position:
FlexiBridge Big Bridge mode
To activate the mode press until you
see the correct mode indicator . This
mode connects the three rear sections
into one cooking area. The front section
is not connected and operates as a
separate cooking zone. You can set the
heat setting for each area separately.
Use the two control bars on the left side.
Correct cookware position:
Make sure to place the cookware on the
three connected sections. If you use
cookware smaller than two sections the
control bar blinks and after 2 minutes the
zone deactivates.
Incorrect cookware position:
ENGLISH 19
To Next Page
Loading...
