Electrolux DMSL8350UO - Troubleshooting

Cleaning the filter
1. Wash the filter in warm water without any
cleaning agents. Detergents can damage
the odour filtration. You can use a soft
sponge, a soft cloth, or a non-abrasive
cleaning brush to remove food remains, if
necessary. You can also wash the filter in
a dishwasher at 65-70 °C (using a
program longer than 90 min), without
detergents and without dishes in the
same load.
2. Dry the filter in the oven for 20-30 min at
70 °C. Place the filter on the middle wire
shelf. Make sure to use a non-fan oven
function. Alternatively, you can leave the
filter to dry overnight at room
temperature. The filter needs to be fully
dried before reassembly.
3. Reassemble the filtering unit and put it
back inside the hood cavity.
Regenerating the filter
1. Clean the filter first, as described above
in step 1.
2. Put the filter in the oven set to 80-110 °C
for 60 min. Place the filter on the middle
wire shelf. Use a non-fan oven function.
3. Reassemble the filtering unit and put it
back inside the hood cavity.
4. Press briefly to reset the counter.
The counter restarts.
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem Possible cause Remedy
You cannot activate or operate
the hob.
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
Check if the hob is correctly connected
to the electrical supply.
The fuse is blown. Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
You did not set the heat setting for
60 seconds.
Activate the hob again and set the
heat setting in less than 60 seconds.
You touched 2 or more sensor fields
at the same time.
Touch only one sensor field.
Pause operates. Refer to "Pause".
There is water or fat stains on the
control panel.
Clean the control panel.
You can hear a constant beep
noise.
The electrical connection is incor‐
rect.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
You cannot select the maximum
heat setting for one of the cook‐
ing zones.
The other zones consume the maxi‐
mum available power.
Your hob works properly.
Reduce the heat setting of the other
cooking zones connected to the same
phase. Refer to "Power management".
26 ENGLISH