• Cut off the mains electrical cable close to
the appliance and dispose of it.
3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Before the installation
Before you install the hob, write down the
information below from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
During installation in combustible matter, NIN
SEV 1000 and fire protection guidelines and
regulations of the Association of Cantonal
Fire Insurance shall be strictly adhered to.
3.3 Electrical connection
Install the hob with a socket supply line. If
there is no socket supply line, the fixed home
electrical system must include an isolating
device with at least a 3 mm-contact
separation to enable a simultaneous and all-
pole cut off from the mains (according to NIN
SEV 1000).
L1
L2
N
PE
L
220V
230V
240V
N
PE
220-240V400V
8 ENGLISH
To Next Page
Loading...
