5
MICROWAVE/ WALL OVEN COMBINATION
INSTALLATION INSTRUCTIONS
The wall oven can tip when the
door is opened. The mounting brackets supplied
with the wall oven must be attached to the
cabinet and the appliance to prevent tipping of
the wall oven and injury to persons.
3 Remove all packaging inside the ovens and remove
the lower oven racks and their supports (see owner's
guide for further instructions).
4 Find the 2 mounting brackets and screws included in
the literature package.
7 Pull the armored cable through the hole for it in the
cabinet and toward the junction box while moving
the appliance inward.
8 Install now the bottom trim using the screws
supplied with the unit (Figure 9).
6 Insert the unit into the cabinet opening. Slide unit
inward leaving 1½" (3.8 cm) clearance between the
unit and front of cabinet (see Figure 8).
Figure 8
1½" (3.8 cm)
clearance
between unit
Figure 7
Mounting
Brackets
40
5
/
16
" (102.4 cm)
F (see Fig. 1)
H (see Fig. 1)
5 Install the 2 anti-tip mounting brackets as shown on
figure 7.
Figure 9
9 Install now the center trim using the screws supplied
with the unit (Figure 10).
Figure 10
To Next Page
Loading...
