1
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
A
B
D
I
27
7
/
8
"
(70.8 cm)
C
HF
G
2" (5.1 cm)
Min.
2
1
/
2
"
(6.4 cm)
Min.
31"*
(78.7 cm)
3" (7.6 cm)
Max.
Spacer
** Door Open
(see note)
Electrical
Junction Box
(not supplied
with unit)
Hole for
cable
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
The first step of your installation should be to measure your current cutout dimensions and compare them
to the cutout dimensions chart below. You may find little or no cabinet work will be necessary.
NOTE:
1.Base must be capable of supporting 200 pounds (90.7 kg).
2. Make sure base is level and front of cabinet is square. If the cabinet base
is not level, the oven glides will tend to slide out
when opening the door.
Figure 1 (Double Wall Oven see page 2)
P/N 318201524 (0709) Rev. C
English – pages 1-8
Español – páginas 9-16
Français – pages 17-24
All dimensions are in inches (cm).
Do not remove spacers on the side walls and/or on the back of the built-in oven. These
spacers center the oven in the space provided. The oven must be centered to prevent excess heat
buildup that may result in heat damage or fire.
PRODUCT DIMENSIONS
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL
30" (76.2 cm) Wall Oven
MODEL
30" (76.2 cm) Wall Oven
A
30 (76.2)
Min. F Max.
28½ (72.4) 29 (73.7)
B
29¼ (74.2)
G (Min.)
24 (61)
C (Rear wrapper)
28¼ (71.5)
Min. H Max.
28
¼
(71.8) 28
7
/
8
(73.3)
D
24
5
/
8
(62.5)
I
30 (76.2) Min
** NOTE: Allow at least 23¼" (59.1 cm)
clearance for door depth when it is open.
NOTE: Dimension G is critical to the proper
installation of the built-in oven. If the oven
decorative moulding does not butt against
the cabinet, or if noise is heard on
convection models, verify dimension G to
assure it is according to the required
dimension.
* Suggested distance from floor is 31"
(78.7 cm).
Minimum required distance is 4½" (11.4
cm).
NOTE: For combination of this Built-in Oven with Warm &
Serve Drawer see cutout dimensions specified in the Warm &
Serve Drawer Installation Instructions.
Printed in United States
Bottom edge
must be finish-cut
To Next Page
Need help?
General
