Problem Possible cause Remedy
The water in the cavity em‐
bossment does not boil.
The temperature is too low. Set the temperature at
least to 110 °C.
Refer to "Hints and tips"
chapter.
The water comes out of
the cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the wa‐
ter with a cloth or sponge.
Add the correct amount of
water to the cavity em‐
bossment. Refer to the
specific procedure.
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
12. ENERGY EFFICIENCY
12.1 Product Fiche and information according to EU 65-66/2014
Supplier's name Electrolux
Model identification
EB7L5XDCN
EB7L5XDSP
Energy Efficiency Index 81.2
Energy efficiency class A+
Energy consumption with a standard load, con‐
ventional mode
0.99 kWh/cycle
Energy consumption with a standard load, fan-
forced mode
0.69 kWh/cycle
Number of cavities 1
Heat source Electricity
ENGLISH 29
To Next Page
Loading...
