7
INSTALLATION (CONTINUED)
1.2.3 - Fitting rear levelling feet
Note: 2 people may be required for this operation
A set of adjustable back feet is provided with the kit. These parts are usually needed only in the case of a particularly
uneven floor and when height adjustments in phase 1.2.1 proved unsuccessfull.
• Temporarily remove the screws (A) holding the
evaporator tray.
• Temporarily remove screw (B)
• Pre-assemble the two nuts to bottom of the foot.
• While one operator is lifting the appliance the
other can assemble the foot with the 2 bolts (D)
and screw (E).
• Repeat the process for the other side.
A
C
E
B
D
To Next Page
Loading...
