ENGLISH
15
Something not working?
If, after the above checks, there is still a fault, call
your local Service Centre.
Please make sure you give the model and serial
number of the appliance.
Before contacting your local Service Centre, please make the following checks.
Important!
If light (End of programme) flashes, the buzzer sounds and an alarm code is displayed, switch the machine
off and call the Service Centre.
Problem Possible cause
• The dryer does not work:
• The door(s) is(are) open.
• The plug is not fitted into the wall socket.
• There is no electricity supply from the wall socket.
• The selector dial is not set correctly.
• The water reservoir is full or not correctly inserted
(light is on
)
. The programme starts in any case
but it stops after approx. 4 minutes.
• The “START/PAUSE” button has not been
depressed.
• The “DELAY START” option has been selected.
• The dryer does not dry properly:
• The filters are clogged.
• The condenser is clogged.
• The water reservoir is full.
• The selected cycle is not suitable for the laundry.
• Insufficient drying time.
• The laundry has not been spun properly.
• The low temperature function “Temperature low.”
has been selected.
• Excessive laundry load.
• The dryer is not correctly installed.
This information can be found on the rating plate
(see picture on page 4).
• The drum light does not light up:
• The Programme/Time selector dial is on position
“0”.
• The lamp is defective.
To Next Page
Loading...
