5
ENGLISH
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons
3 and 6 until «C0» appears on the digits.
Adjusting the level of conductivity:
Press the button 5 sequentially: the level of
conductivity is indicated by the lighting of the
horizontal hyphens.
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorizing the new setting:
Simultaneously press down the buttons 3 and 6 until
the previous drying cycle time appears again on the
display and the buzzer sounds.
Display
Conductivity
degree
Approximative
value (µS/cm)
CC 00
Low < 300
CC 00
Medium 300 - 600
CC 00
High > 600
To Next Page
Loading...
