12
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble
dryer.
Drying
1. Connect the appliance.
2. Open the door.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Press the ON/OFF button : the mainsON
light comes on.
6. Select the drying programme or time.
7. If required, press the low temperature button
and/or the buzzer OFF button .
8. Press the Start button for 2 seconds: light
comes on and
drying starts.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light is on).
You may remove the laundry after this phase.
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anticreasing
phase (duration: 30 minutes maximum).
The buzzer sounds every 10 seconds (if the
button has not been pressed).
Lights and flash alternately.
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreasing
phase.
Light flashes and the mainsON light stays on.
Turn the programme selector dial to “0”; light
goes out.
Release the ON/OFF button (the mainsON light
goes out) and immediately remove the laundry.
After each use
• Turn the programme selector dial to “0”.
• Switch the appliance off by releasing the ON/OFF
button . The mainsON light goes out.
• Clean the filter (see page 14).
Important!
If the drying programme has to be stopped before
it reaches the end, we recommend that you turn the
programme selector dial to position (cooling)
and wait until the end of this phase before removing
the laundry. This will avoid a buildup of heat inside
the appliance.
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
“0”. Select the new programme and press the Start
button .
To Next Page
Loading...
