EasyManua.ls Logo

Electrolux EEA17200L - Before First Use; Salt Container Information; Filling the Salt Container

Electrolux EEA17200L
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AirDry is automatically activated with all
programmes excluding
(if
applicable).
The duration of the drying phase and the
door opening time vary depending on the
selected programme and options.
CAUTION!
If children have access to
the appliance, it is advised to
deactivate AirDry as opening
the door may pose a danger.
How to deactivate the AirDry
Make sure the appliance is in user mode.
1. Press the programme button three
times.
The indicator
starts to flash.
2. Wait until the indicator continues
to flash and the remaining
programme indicators are off.
The indicator shows the current
setting:
is off = AirDry is off.
is on = AirDry is on.
3. Press the programme button to
change the setting.
4. Press the on/off button to confirm the
setting.
8. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
8.2 How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.
6. Turn the cap of the salt container
clockwise to close the salt container.
www.electrolux.com12

Related product manuals