Problem and alarm code Possible cause and solution
The programme lasts too long. • If the delayed start option is set, cancel the
delay setting or wait for the end of the
countdown.
• Refer to the consumption values table in the
chapter "Programmes".
Small leak from the appliance door. • The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• The appliance door is not centred on the
tub. Adjust the rear foot (if applicable).
The appliance door is difficult to
close.
• The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• Parts of the tableware are protruding from
the baskets.
The appliance door opens during
the wash cycle.
• The AirDry function is activated. You can
deactivate the function. Refer to "Settings".
Rattling/knocking sounds from in‐
side the appliance.
• The tableware is not properly arranged in
the baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate
freely.
The appliance trips the circuit-beak‐
er.
• The amperage is insufficient to supply si‐
multaneously all the appliances in use.
Check the socket amperage and the capaci‐
ty of the meter or turn off one of the applian‐
ces in use.
• Internal electrical fault of the appliance.
Contact an Authorised Service Centre.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
WARNING!
We do not recommend using
the appliance until the
problem has been
completely fixed. Unplug the
appliance and do not plug it
in again until you are certain
that it operates correctly.
www.electrolux.com20
To Next Page
Loading...
