Electrolux EES200E/5503S - Operating Dial Functions; Initial Setup and First Use

5
Operating Dial
The operating dial has three settings:
1. Dispensing steam/hot water via the steam nozzle
2. Pump switched o / neutral position
3. Pump switched on: dispensing espresso via the boiler outlet
4. Assoonastheoperatingdialisturnedfromitsneutralposition,eitherthesteam
nozzle or boiler outlet will open, and steam or hot water will be emitted.
Before Using For The First Time
Before the appliance is used for the rst time, all detachable parts must be thoroughly
cleanedasdescribedinthesection“CareandCleaning”.Retthedriptrayanddrainer
to the appliance afterwards. Clean the system by ushing with hot water as follows:
1. Fill the container with water.
2. Insert the lter holder with the lter sieve, but without putting any ground coee in.
3. Place a container, e.g. a suitably sized cup, underneath the outlet openings.
4. Insert the plug into a wall outlet.
5. Setthehot-water/steamselectortothehot-waterposition(buttonreleased).
6. UsetheOn/Oswitchtoturntheapplianceon,andactivatetheoperatingdial
(position ).
7. Hot water is emitted from the outlets.
8. Leave the pump running until about half the water in the water container has
passed through.
9. Then switch o the pump by turning the operating dial to its neutral position.
10. Empty the cup and place it under the steam nozzle. Turn the operating dial to
position .
11. Water is now emitted through the steam nozzle.
12. Let the water pass through until the amount left in the container has reached the
‘Min.’ mark.
13. Switch o the pump by turning the operating dial to its neutral position.
14. This procedure should also be followed if the appliance has not been used for an
extended period of time.
EN