Electrolux EES200E/5503S - Appliance Operation Guide; Filling the Water Tank; Filter Holder Installation

6
Operation
Filling with water
 Fill only with fresh water on a daily basis; make sure that the water container is
cleaned at regular intervals. Do not switch the appliance on unless the water
container is lled.
* Lift up the water container lid and ip it back.
* Lift out the water container.
* Fillthecontainerwith(non-carbonated)coldwaterwhileobservingthe
‘Max’ marking on the water container.
* Once lled, replace the container in the appliance and push it down in
order to open the valve in the bottom.
* Close the lid on the water container.
• The water level must be monitored and, if necessary, the container relled in good
time.
• Shouldthepumphavestartedsuckinginairfromtheemptywatercontainer,ll
the water container rst with the indicated maximum amount of water. When
‘bleeding’ the system afterwards, it may take a few moments before water is
emitted again.
• Depositsofdirtandlimemaycausethesealsintheoutletatthebottomofthewater
container and those around the valves to leak. Check the seals carefully each time the
water container is inserted and, if necessary, carefully remove any existing deposits.
Inserting/removing the lter holder
• Thelterholderisttedtotheappliancebymeansofabayonettypelocking
socket. When attaching the lter holder, its handle must be facing to the left of the
boileroutlet(a).Tolock,turnthelterholderrmlyasfaraspossibletotheright
(b),i.e.inananti-clockwisedirection.
EN
(a) (b)