Electrolux EES200E/5503S - Controls and Preheating; Hot-Water;Steam Selector; Cup and Filter Preheating

7
• Tounlockandremovethelterholder,turnittotheleft,i.e.clockwise.
• Donotremovethelterholderwhiletheapplianceisinuse,sincethelterholder
is under pressure. Once the brewing cycle is complete, wait around 30 seconds
before removing the lter holder.
Hot-water/steam selector button
This selector allows you to choose either hot water or steam.
• Todispensehotwater,thebuttonmustbeinitsreleasedposition.Thehotwater
can now be drawn through either the boiler outlet or the steam outlet.
• Todispensesteam,theselectorbuttonmustbepushedin.Thesteamcanbe
drawn through the steam nozzle using the valve selector control.
Preheating the cups and the lter holder
We recommend pre-heating the cups and the lter holder, as this will ensure a higher
coee temperature.
1. Insert the appropriate filter sieve for 1 or 2 cups into the filter holder.
2. Fit the filter holder to the appliance and place one or two cups underneath the
holder.
3. Assoonastheoperatingtemperaturehasbeenreached,thetemperature
indicator light will turn off.
4. Turn the operating dial to the symbol.
5. Letthecup(s)filluptoapproximately3/4,andthenturntheoperatingdialtoits
neutral position to switch off the pump.
6. Putthecup(s)asidetowarmupandpouroutthewaterjustpriortomaking
espresso. The cups may also be placed on the warming top to pre-heat them.
EN