EasyManua.ls Logo

Electrolux EES200E/5503S - Coffee Preparation Steps; Filling the Coffee Filter; Removing Used Coffee Grounds

Electrolux EES200E/5503S
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Filling the lter sieve with ground coee
• Removethepreheatedlterholder
(Caution:thelterholderishot).
• Fillwithnelygroundcoee:
- 1 cup = 1 level measuring scoop
- 2 cups = 2 level measuring scoops
• Note:ifthelterholderisover-lled,itwillnotlockproperlyundertheboiler
outlet. 2 level measuring scoops is the maximum quantity.
• Usethemeasuringscooptodistributethegroundcoeeevenlyandpressitdown
lightly.Anyexcesscoeepowderontherimofthelterholdermustberemoved.
Removing the used grounds
• Afterthebrewingcycleiscomplete,waitapproximately30secondsuntilthe
operating pressure has been suciently reduced.
• Exercisecautionwhenremovingthelterholder:itmaystillcontainsomehot
water.
• Pleasenotethat,whenpreparing2cupsofespresso,slightlymorewaterwill
remain on the espresso grounds.
• Toremovethecoeegrounds,gentlytapthesideofthelterholderagainsta
vertical surface. Wipe the lter holder thoroughly clean afterwards.
EN

Related product manuals