You can turn the selector of the released
quantity (B) between position 1 (lowest
quantity) and position 4 or 6 (highest
quantity).
9. DAILY USE
1. Open the water tap.
2. Press and hold until the appliance is
activated.
3. Fill the salt container if it is empty.
4. Fill the rinse aid dispenser if it is empty.
5. Load the baskets.
6. Add the detergent.
7. Select and start a programme.
8. Close the water tap when the programme
is complete.
9.1 Using the detergent
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets, in
the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the release
button locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
Do not fill the compartment (A) with more
than 30 ml of gel detergent.
9.2 How to select and start a
programme using MY TIME
selection bar
1. Slide your finger across MY TIME
selection bar to choose a suitable
programme.
• The light related to the selected
programme is on.
• The ECOMETER indicates the level of
energy and water consumption.
• The display shows the programme
duration.
2. Activate applicable EXTRAS if desired.
3. Close the appliance door to start the
programme.
9.3 How to select and start the
programme Pre-rinse
1. To select Pre-rinse, press and hold
for 3 seconds.
• The light related to the button is on.
• The ECOMETER is off.
• The display shows the programme
duration.
2. Close the appliance door to start the
programme.
16 ENGLISH
To Next Page
Loading...
