Electrolux EI26SS30JS - Page 38

38
Solutions To Common Problems
Water/Moisture/Frost Inside Refrigerator
Problem Cause Correction
Moisture collects on inside
of refrigerator walls.
• Weather is hot and
humid.
• Door is slightly
open.
• Door is opened too
often or too long.
• Open containers.
• The rate of frost buildup and internal sweating
increases.
• See Problem section, Opening/Closing of Doors/
Drawers.
• Open door less often to allow internal
temperature to stabilize.
• Keep containers covered.
Water collects on bottom
side of drawer cover.
• Vegetables contain
and give off
moisture.
• Moisture on the bottom side of the cover is not
unusual.
• Move humidity control (some models) to lower
setting.
Moisture collects in bottom
of drawer.
• Washed vegetables
and fruit drain while
in the drawer.
• Fruits and vegetables
are kept past their
prime
• Dry items before putting them in the drawer.
Water collecting in bottom of drawer is normal.
• Routinely clean out old fruits and vegetables
especially if they begin to break down.
Moisture collects on
outside of refrigerator or
between doors.
• Weather is humid.
• Door is slightly
open, causing cold
air from inside
refrigerator to meet
warm air from
outside.
• This is normal in humid weather. When
humidity is lower, the moisture should
disappear.
• See Problem section, Opening/Closing of Doors/
Drawers.
Perfect Temp Drawer (some models)
Problem Cause Correction
Display does not illuminate
or shows “CE”.
• Connector not
connected or loose.
• Remove pan and insure connector is fully
engaged. (See Storage Features section)
Display shows “LOC” when
buttons are pressed.
• Drawer in control
lock mode.
• Press and hold control lock button for three
seconds to take drawer out of control lock
mode. (See Storage Features section)