:32 Electronic Control Settings
USERPREFERENCES(CONTINUED)
Ill [] I! I! [] [] [] [] [] [] Ill [] I! [] II [] III I! [] [] III []
SETTINGCLOCK DISPLAY-- ON OROFF
The oven control can be programmed to display the time of day or not. The oven has been
preset at the factory to display the time of day.
Changing clock disp_ between ON and OFF:
1 Press USER PREF _r-_' until you get to the CLO on menu page.
4-
2. Press hi or Uoto_ggle between displaying or hiding the clock.
3. Press START I_ to accept the changes and go back to user preferences menu
display.
SETTINGTiME OF DAYDISPLAY-- 12OR 24 HOURS
The oven control can be programmed to display time of day in 12 hours or 24 hours mode.
The oven has been preset at the factory to display in 12 hours mode.
Changing between 12or 24 hour time ofday display:
1, Press USER PREF _J until you get to the CLO 12hr menu page,
+
2 Press h_or Io to t_oggle the display of the clock in 12 or 24 hours.
3 Press START {1_ to accept the changes and go back to user preferences menu
display.
4. Remember to set your clock after changing the time of day display mode.
ADJUSTINGOVEN TEMPE_.TURE
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool,
the temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed. Each oven can be
individually adjusted.
To adjust the oven temperature:
1. Press USER PREFERENCES _ until you get to the UPO menu page.
+
2. Enter the temperature by pressing the hi or Io pads. The temperature can only be
adjusted by _+35°R
3. Press START I_ to accept the changes and go back to user preferences menu
display.
To Next Page
Loading...
