4
Using the cooker hob
Control knobs on the gas hob
The knobs for using the gas hob of the cooker are found
on the control panel. The regulation knobs hould be
turned in anti-clockwise direction until the small flame
symbol, and vice-versa for the larger symbol.
No gas supply
Maximum gas supply
Minimum gas supply
Ignition of hob burners
To ignite a burner, before positioning the saucepan,
proceed as follows:
1. push the corresponding knob in completely
and turn in an anticlockwise direction to the
maximum position;
2. upon ignition regulate the flame as required.
In models provided with a safety device
("thermocouple", fig. 1 - D), the control knob must be
pressed in for approximately 5 seconds until the
safety valve automatically keeps the flame lit.
If after a few attempts the burner does not ignite, check
that the burner cap and crown (fig.1-A,B) are correctly
positioned.
To interrupt the supply of gas, turn the knob in a
clockwise direction to the position "l".
During cooking, when using fats or oils, take
particular care as they can, when over-
heated, self-ignite.
When using the triple-crown burner, place
the special grid on the pan support (fig.2-A).
When using the auxiliary burner (with pans
having a diameter equal or higher than
50mm), place the special grid on the pan
support, as shown in fig.2-B.
Triple-crown burner
In models provided with triple-crown burner, always
ignite the burner before putting the pans on.
If after a few attempts the burner does not ignite, check
that the burner cap and crown are correctly positioned.
Control knob for the hotplates
The hotplates control knob (EK 6735 - 9735) can be
adjusted on four different positions, according to your
cooking needs, from maximun heat (position 4) to
minimum heat (position 1), as shown in Fig.3.
Burner min diam max diam
Triple-crown (large) ø 220 mm ø 260 mm
Semi-rapid (medium) ø 120 mm ø 220 mm
Auxiliary (small) ø 80 mm ø 160 mm
Fish kettle burner 120 x 270 210 x 380
Table of minimum and maximum diameters of
recipients to be placed on burners
Fig. 2
F
Fig. 3
0
1
2
3
4
FO 2193
Fig. 1
FO 0204
A - Burner Cap
B - Burner crown
C -Spark generator
D - Thermocouple
A
B
D
C
B
A
To Next Page
Loading...
