3. Clean the oven ceiling with a soft cloth
with warm water and a cleaning agent,
and let it dry.
Install the heating element in the opposite
sequence.
Install the shelf supports.
WARNING!
Make sure that the heating element is
correctly installed and that it does not fall
down.
11.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.8 The drawer
WARNING!
Do not put food inside the drawer.
WARNING!
Do not keep flammable items such as
cleaning materials, plastic bags, oven
gloves, paper, cleaning products,
aerosols, plastic items) in the drawer.
When you use the oven, the drawer can
become hot. There is a risk of fire.
The drawer below the oven can be removed
for cleaning.
Removing the drawer:
1. Pull the drawer out until it stops.
2. Lift the drawer slightly, so that can be
lifted upwards at an angle of the drawer
guides.
To install the drawer, follow the procedure in
reverse.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem Possible cause Remedy
You cannot activate the appliance. The appliance is not connected to
an electrical supply or it is connec‐
ted incorrectly.
Check if the appliance is correctly
connected to the electrical supply.
You cannot activate the appliance. The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
30 ENGLISH
To Next Page
Loading...
