English
GETTING THE BEST RESULTS
Use the nozzles as follows:
Rugs: Use the rug/hard floor nozzle with the lever in position (1).
Reduce suction power for small rugs.
Hard floors: Use the rug/hard floor nozzle with the lever in
position (2).
Wooden floors: Use the parquet nozzle (certain models only, 3).
Upholstered furniture: Use the combination nozzle as shown in
(4).
Curtains, lightweight fabrics, etc.: Use the combination nozzle
as shown in (4). Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the combination nozzle as
shown in (5) or duster (6 – certain models only).
Crevices, corners, etc.: Use the crevice nozzle (7).
Using the turbo nozzle
8 Attach the nozzle to the tube.
9 Adjust the suction power by opening or closing the air vent.
Note: Do not use the turbo nozzle on skin rugs, rugs with long fringes
or a pile depth exceeding 1/2". To avoid damaging the rug, do not
keep the nozzle stationary while the brush is rotating. Do not pass the
nozzle across electric cables, and be sure to switch off the vacuum cleaner
immediately after use.
To Next Page
Loading...
