Step 3 Close the oven door halfway to
the first opening position. Then
lift and pull forward and remove
the door from its seat.
Step 4 Put the door on a soft cloth on a
stable surface.
Step 5 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the
clip seal.
Step 6 Pull the door trim to the front to
remove it.
Step 7 Hold the door glass panel by its
top edge and carefully pull it out.
Make sure the glass slides out of
the supports completely.
Step 8 Clean the glass panels with wa‐
ter and soap. Dry the glass pan‐
els carefully. Do not clean the
glass panels in the dishwasher.
Step 9 After cleaning, install the glass
panel and the oven door.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
ENGLISH 29
To Next Page
Loading...
