EasyManuals Logo

Electrolux EOD3C70TK User Manual

Electrolux EOD3C70TK
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
12.2 Stainless steel or
aluminium ovens
Clean the oven door with a damp cloth or
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel
with the same precautions.
12.3 Cleaning the cavity
embossment
The cleaning procedure removes
limestone residue from the cavity
embossment after cooking with steam.
For the function: True Fan
Cooking PLUS we
recommend to do the
cleaning procedure at least
every 5 - 10 cooking cycles.
1. Put 250 ml of white vinegar into the
cavity embossment at the bottom of
the oven.
Use maximum 6% vinegar without
any additives.
2. Let the vinegar dissolve the residual
limestone at the ambient temperature
for 30 minutes.
3. Clean the cavity with warm water and
a soft cloth.
12.4 Cleaning the door gasket
Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the oven if
the door gasket is damaged. Contact an
Authorised Service Centre.
To clean the door gasket, refer to the
general information about cleaning.
12.5 Removing the shelf
supports / catalytic panels
To clean the oven, remove the shelf
supports / catalytic panels.
CAUTION!
Be careful when you remove
the shelf supports. The
catalytic panels are not
attached to the oven walls
and can fall out when you
remove the shelf supports.
1. Pull the front of the shelf support
away from the side wall. Hold the
rear shelf runners and catalytic panel
in place with the other hand.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
12.6 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
remove all the accessories .
clean the oven floor with warm water
and mild detergent.
clean the inner door glass with warm
water and soft cloth.
1. Set the function
.
2. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
3. Turn off the oven.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
www.electrolux.com28

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Electrolux EOD3C70TK and is the answer not in the manual?

Electrolux EOD3C70TK Specifications

General IconGeneral
Door hingedown
Cord length1.6 m
Control typeRotary, Touch
Product colorBlack
Built-in displayYes
Control positionTop right / left
Oven door openingDrop down opening
Appliance placement-
Connected load2990 W
AC input voltage220 - 240 V
AC input frequency50 / 60 Hz
Energy efficiency scaleA+++ to D
Energy consumption (conventional)0.95 kWh
Energy consumption (forced convection)0.81 kWh
Lamp typeHalogen
Bulb power40 W
Lamps quantity1 lamp(s)
Package depth670 mm
Package width635 mm
Package height654 mm
Package weight30800 g
Number of baking trays1
Oven sizeMedium
Oven typeElectric
Total oven power- W
Bottom heating power1000 W
Oven thermostat range50 - 275 °C
Total oven(s) interior capacity72 L
Weight and Dimensions IconWeight and Dimensions
Depth569 mm
Width596 mm
Height594 mm
Weight29800 g
Installation compartment depth550 mm
Installation compartment width560 mm
Installation compartment height600 mm

Related product manuals