–
rigid metal pipe(annealed copper Ø
8mm), insert the copper pipe in the gas
train union after positioning the nut and
double cone, which are included in the
bag of accessories.
1
2
3
1 Rigid pipe
2 Nut
3 Double conne
2. To complete the connection, tighten the
nuts with a 24 mm wrench, taking care
not to mechanically stress the gas circuit.
3. Insert the oven in the cabinet and fix it as
indicated in the section “Fixing to the cab-
inet”, making sure the gas supply con-
nection pipe is not crushed.
IMPORTANT:
After installation, always check the per-
fect seal of all unions using a soapy sol-
ution. Never carry out this check with a
flame.
Conversion to different types of gas
To convert the appliance to a different type
of gas from that for which it is arranged, the
nozzle must be replaced with one suitable for
the new type of gas.
The oven burner does not require pri-
mary air adjustment.
Replacing the oven burner nozzle
1. Remove the bottom of the oven (“A”);
2. Undo the two screws (“C”) fixing the
burner;
electrolux 17
To Next Page