3. Slowly remove the burner from the nozzle
holder, making sure the burner bush re-
mains in the correct position inside the
burner; carefully move the burner to the
left, avoiding any kind of strain on the ig-
niter plug connection cable (“E”);
4. Undo the nozzle (“D”) with the special 7
mm wrench and replace it with one suit-
able for the new type of gas (refer to the
table “Oven burner specifications”).
5. Then refit everything, repeating the oper-
ations in reverse order.
6. Replace the rating plate (located near the
gas connection) with that corresponding
to the new type of gas, included in the
bag of injectors supplied.
Oven burner specifications
GAS TYPE INJECTOR
MARK 1/100
mm
NOMINAL
GAS POWER
(kW)
NOMINAL GAS FOLLOW IN NOMINAL
GAS PRES-
SURE (mbar)
m3/h g/h
NaturalGas
(G20)
114 2.7 0.257 - 20
LPG (G30/
G31)
078 2.5 - 182 30
NaturalGas
(G20)
124 2.5 0.238 - 13
What to do if…
If the appliance is not working correctly,
please check the following before contacting
the Electrolux Service Centre:
Important! If you call out an engineer to a
fault listed below, or to repair a fault caused
by incorrect use or installation, a charge will
be made even if the appliance is under
guarantee.
PROBLEM SOLUTION
The oven is not switching on. • Check that both a cooking function and tem-
perature have been selected
• Check whether the appliance is correctly con-
nected and the socket switch or the mains sup-
ply to the oven is ON
The oven temperature light does not come on . • Select a temperature with the thermostat con-
trol knob
• Select a function with the oven function control
knob
18 electrolux
To Next Page
Loading...