Electrolux EQE6007SB - Refrigerator Installation Guide; Ventilation and Levelling; Connecting Power and Initial Setup

1 To ensure adequate ventilation for your refrigerator, it
is recommended to provide space of 60mm on both
sides and at the back, and space of 90mm above the
refrigerator. Insufficient spacing will decrease cooling
efficiency, increase energy consumption and may reduce
the life of the unit (see page 3).
2 Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3 Using the adjustable feet, raise the front of the unit so it
leans back slightly, this will assist in door closing. Make
nal adjustments to ensure that the doors are correctly
aligned.
4 Remove the 4 screws from the bottom of the refrigerator
and use these to fit the kickplate (supplied inside the
refrigerator compartment).
5 Connect the power plug to a 240 volt 10 amp power
point.
NOTES:
• Positionyourrefrigeratorsothattheplugisaccessible.
• Keepyourrefrigeratoroutofdirectsunlight.
• Donotplacenexttoaheatgeneratingappliance.
• Thisrefrigeratorisdesignedforindooruseonly–donot
placetheunitonanunsealedsurface.
• Toavoidvibrationandmisalignmentofthedoors,theunit
mustbelevel.Placetheunitonasolidatsurface.Uneven
oorseg.slate,tilesandoorboards,cancausetheunitto
sagovertimecausingthedoorstobecomemisaligned.
• Ifthemainspowerisswitchedonwhenthedoorisopen,
thedooralarmwillsound.Closethedoortostopthealarm.
Installation
2 installation electrolux four-door refrigerator
Whentransporting
• Using the rollers, it is possible to move back and forth.
Carry the refrigerator by holding the holding devices
located on the rear and bottom.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water. If soapy water is used, wipe it off thoroughly.
When the left
door is raised
When the right
door is raised
Lower the foot
at right side*
Lower the foot
at left side*
*Until the adjustable foot on the
other side is slightly off ground.
Adjustable feet
Screw
(4 screws)
Screw
Kickplate